NEC Xen Master - 3-05 Trunk Incoming Answer Mode Selection

Trunk Incoming Answer Mode Selection 1 - 267
Programming Manual May 2003
A6-324000-642-02 - Release 6.0 May 2003
3-05
System Mode
3
Submode
—
Data No.
05
PC Programming
a
+BCT
Trunk Incoming Answer Mode
Selection
General Description
This Memory Block specifies, per outside line, the incoming answer mode (Automatic
Trunk-to-Trunk Transfer, Automated Attendant, or DISA).
Display
Settings
LK 1LK 2LK 3LK 4
The shaded area indicates the default setting.
Normal
Automatic
Trunk-to-
Trunk
Transfer
Automated
Attendant/
DISA
LK 5 LK 6 LK 7 LK 8
Programming Procedures
1 Go off-line.
2 Press LK3 +
N + KEto access the Memory Block.
3 Press the corresponding CO/PBX line key to change the data option.
Note: Use the following to enter data:
R to go to the next CO/PBX Port No.
4 PressNto write the data.
5 Press
Pto go back on-line.
Related Programming
M.B. Number Memory Block Name
Refer to Chapter 2 Guide to Feature Programming
0 1 / 0 5 : N O A S S I G N
T I M E D I S P L A Y
CO/PBX
No.
(01~64)
Data
No.
Setting
Data
Line Key
LCD
Indication
when Selected
Definition
LK 1 NO ASSIGN Normal
LK 2 TANDM TRF Automatic Trunk-to-Trunk Transfer
LK 3 AA Automated Attendant/DISA