1 - 266 Trunk-to-Trunk Transfer Yes/No Selection
NEC Business Solutions Ltd Xen Master & Xen Axis
A6-324000-642-02 - Release 6.0
May 2003
3-04
System Mode
3
Submode
—
Data No.
04
PC Programming
a
+BCT
Trunk-to-Trunk Transfer Yes/No
Selection
General Description
This Memory Block specifies whether or not to allow Trunk-to-Trunk Transfer.
Display
Settings
LK 1 LK 2 LK 3 LK 4
The shaded area indicates the default setting.
No Yes
LK 5 LK 6 LK 7 LK 8
Programming Procedures
1 Go off-line.
2 Press LK3 +
N + KDto access the Memory Block.
3 Press the corresponding CO/PBX line key to change the data option.
Note: Use the following to enter data:
J to move the cursor left
L to move the cursor right
K~I to enter numeric data
R to go to the next CO/PBX Line No.
4 Press
Nto write the data.
5 PressPto go back on-line.
Related Programming
M.B. Number Memory Block Name
1-8-07
Class of Service (Attendant) Feature Selection 1
1-8-08
Class of Service (Station) Feature Selection 2
3-05
Trunk Incoming Answer Mode Selection
3-06
Automatic Tandem Trunk Assignment
5-01
Tie Line Networking Tandem Connection Assignment
N
Assign Yes to connect both trunks via Trunk-to-Trunk Transfer or Automatic Trunk-to-Trunk Transfer feature.
0 1 / 0 4 : T R F Y S
T I M E D I S P L A Y
CO/PBX
No.
(01~64)
Setting
Data
Title
To Next Page
Loading...
Need help?
General
