NEC Xen Master - 1-2-22 Call Forward No Answer Timer Selection

1 - 128 Call Forward No Answer Timer Selection
NEC Business Solutions Ltd Xen Master & Xen Axis
A6-324000-642-02 - Release 6.0 May 2003
1-2-22
System Mode
1
Submode
2
Data No.
22
PC Programming
a
+BM
Call Forward No Answer Timer
Selection
General Description
Use this Memory Block to specify the time before incoming intercom calls or incoming CO/
PBX lines are forwarded to another station number if the called party does not answer.
Display
Settings
LK 1 LK 2 LK 3 LK 4
The shaded area indicates the default setting.
4 sec. 8 sec. 12 sec. 18 sec.
LK 5 LK 6 LK 7 LK 8
24 sec. 30 sec. 60 sec.
Programming Procedures
1 Go off-line.
2 Press LK1 + LK2 +
BB to access the Memory Block.
3 Press the corresponding CO/PBX line key to change the data option.
4 Press
Nto write the data.
5 Press
Pto go back on-line.
Related Programming
M.B. Number Memory Block Name
1-1-46
Access Code (1-Digit) Assignment
1-1-47
Access Code (2-Digit) Assignment
1-1-48
Access Code (3-Digit) Assignment
1-2-01
Intercom Call Voice/Tone Signal Selection
1-8-08
Class of Service (Station) Feature Selection 2
4-17
Station to Class of Service Feature Assignment
4-43
Call Forward-Busy Immediately/Delay Selection
N
1. For ACD Call Forward No Answer time refer to Memory Block 1-8-40.
2. This will effect ICM, DIT, DID, TLI calls. CO Ringing Assigned Calls do not follow this Memory Block setting.
2 2 : F W D N O A N S 8 s
T I M E D I S P L A Y
Data
No.
Title
Setting
Data