Trunk Name/Number Assignment 1 - 263
Programming Manual May 2003
A6-324000-642-02 - Release 6.0
May 2003
3-00
System Mode
3
Submode
—
Data No.
00
PC Programming
a
+BCT
Trunk Name/Number Assignment
General Description
Use this Memory Block to specify telephone name/number for the CO/PBX lines
accommodated so that the information is displayed when the CO/PBX Line is seized, or
during an incoming call.
Display
Settings
LK 1LK 2LK 3LK 4
There is no default setting.
Number Name
LK 5 LK 6 LK 7 LK 8
Programming Procedures
1 Go off-line.
2 Press LK3 +
KK to access the Memory Block.
3 Use the dial pad to enter data.
Note: Use the following enter data:
J to moves the cursor left
L to moves the cursor right
K~I to numeric keys for entering data
Q to generate a - (hyphen)
U to generate a space (clear after hold)
R to go to the next CO/PBX Line No.
Default Values
Not Specified
4 Press
Nto write the data.
5 Press
Pto go back on-line.
Related Programming
No related programming is necessary for this Memory Block.
N
When a name is selected, use Section 7 Character Code Tables on page 1-442 to get the character codes.
0 1 / 9 7 2 - 7 5 1 - 7 0 0 0
T I M E D I S P L A Y
CO/PBX No.
(01~64)
Setting Data
(13 digits maximum)
To Next Page
Loading...
Need help?
General
