NEC Xen Master Programming Manual

Line Selection for Automatic Outgoing Calls 1 - 47
Programming Manual May 2003
A6-324000-642-02 - Release 6.0 May 2003
1-1-19
System Mode
1
Submode
1
Data No.
19
PC Programming
a
+BO
Line Selection for Automatic
Outgoing Calls
General Description
Use this Memory Block to specify which trunks will be used when a call is made using the
Code Restriction Password Override Feature.
Display
Settings
LK 1LK 2LK 3LK 4
The shaded area indicates the default setting.
NON CO B PBX TIE
LK 5 LK 6 LK 7 LK 8
TG XX RAB XX
Programming Procedures
1 Go off-line.
2 Press LK1 +
LK1 + AI to access the Memory Block.
3 Press the corresponding CO/PBX line key to change the data option.
4 Press
Nto write the data.
5 Press
Pto go back on-line.
Related Programming
No related programming is necessary for this Memory Block.
N
1. Requires System Software version 5.0 or higher.
1 9 : O G = T G 0 1
T I M E D I S P L A Y
Data
No. Title
Setting
Data

NEC Xen Master Specifications

General

Brand	NEC
Model	Xen Master
Category	Telephone
Language	English