1 - 90 8-Digit Matching Table Assignment
NEC Business Solutions Ltd Xen Master & Xen Axis
A6-324000-642-02 - Release 6.0
May 2003
1-1-60
System Mode
1
Submode
1
Data No.
60
PC Programming
a
+AC
8-Digit Matching Table Assignment
General Description
Use this Memory Block to assign the outgoing dial digit for Code Restriction (except OCC
Dial Digit - Normal Dial). Program this assignment in one of two ways:
a) When the user dials digit(s) and there is a match, the system allows free dialling or
denies dialling by disconnecting. Refer to Memory Block 1-1-61, 8-Digit Matching
Table to Class Assignment for programming.
b) When a user dials digit(s) and there is no match, the system allows free dialling or
denies dialling by disconnecting. Refer to Memory Block 1-1-65, Code Restriction
Class Allow/Deny Selection for programming.
Display
Programming Procedures
1 Go off-line.
2 Press LK1 + LK1 +
FK to access the Memory Block.
3 Use the dial pad to enter the data.
Note: Use the following to enter data:
J to move the cursor left
L to move the cursor right
K~Ito enter numeric data
U to clear data
The information that can be entered includes:
Matching Table: 00~15 (8-digit)
Dial Code: 00~15
Dial Digit: 0~9, , #, X, P, N (Maximum eight digits)
Default Values
4 Operation data includes:
5 Press
Nto write the data and advance to the next dial code. After all dial codes have been entered, pressNagain.
6 Press
Nto go back on-line.
6 0 : 8 D I G I T T A B L E
0 0 / 0 0 = 0 0 0
Data
No.
Title
Dial
Code
Dial Digit
(Maximum 8)
8-Digit
Matching
Table
Matching
Table
Dial
Code
Setting
Data
00
00 000
01 1144x
Operation Data Dial Number Operation
X K~I,J,L Q + G
P KandA Q +H
N B~I Q +I
 J Q +J
# L Q +L
To Next Page
Loading...
Need help?
General
