Automatic Day/Night Mode Switching Time Assignment 1 - 55
Programming Manual May 2003
A6-324000-642-02 - Release 6.0
May 2003
1-1-27
System Mode
1
Submode
1
Data No.
27
PC Programming
a
+BM
Automatic Day/Night Mode
Switching Time Assignment
General Description
Use this Memory Block to assign Pattern 1 and Pattern 2 start times for automatically
switching between Day Mode and Night Mode.
Display
Programming Procedures
1 Go off-line.
2 Press LK1 +
LK1 + BG to access the Memory Block.
3 Enter the data using the dial pad.
Note: Use the following to enter data:
J to move the cursor left
L to move the cursor right
K~I to enter numeric data
U to clear all data when the cursor is in the Data No. position
Default Values
Not Specified
4 Press
Nto write the data. The switching time for pattern 2 is displayed.
5 Use the dial pad to change the time.
6 Press
Nto write the data.
7 Press
Pto go back on-line.
Related Programming
M.B. Number Memory Block Name
1-1-32
Automatic Day/Night Mode by Day of Week Selection
1-4-05
Automatic Tandem Trunk by Night Mode Selection
1-8-07
Class of Service (Attendant) Feature Selection 1
4-07
Code Restriction Class Assignment (Day Mode)
4-08
Code Restriction Class Assignment (Night Mode)
4-09
Telephone to Tenant Assignment
4-17
Station to Class of Service Feature Assignment
4-37
Extension Line Key Ring Assignment (Day Mode)
4-38
Extension Line Key Ring Assignment (Night Mode)
2 7 : 1 : , :
T I M E D I S P L A Y
Data
No.
Day Mode
Start Time
Setting Data
Pattern
(1/2)
Night Mode
Start Time
Setting Data