NEC Xen Master Programming Manual

Trunk Group Mode Copy Assignment 1 - 401
Programming Manual May 2003
A6-324000-642-02 - Release 6.0 May 2003
6-5
System Mode
6
Trunk Group
5
Data No.
—
Trunk Group Mode Copy
Assignment
General Description
Use this Memory Block to enable copying data from one Trunk Group to another Trunk
Group or multiple consecutive Trunk Groups.
Example: To copy data of Trunk Group 01 to Trunk Groups 10~14:
1. Enter the original Trunk Group using the dial pad; press 01~32.
2. Press
N.
3. Enter the Start Trunk Group No. (01~32). Using the dial pad, press
AK.
Display
Programming Procedures
1 Go off-line.
2 Press LK6 +
LK5 to access the Memory Block.
3 Enter the Trunk Group to be copied.
Note: Use the following to enter data:
K~I to enter numeric data
U to clear all data when placed at cursor position
Related Programming
No related programming is necessary for this Memory Block.
T R K G P — —
Æ
T I M E D I S P L A Y
Title
Setting
Data
T R K G P 0 1 — —
Æ
T I M E D I S P L A Y
Title
Setting
Data
— —
Æ
T R K G P —
T I M E D I S P L A Y
Title
Setting
Data
— —
Æ
T R K G P 1 0 —
T I M E D I S P L A Y
Title
Setting
Data

NEC Xen Master Specifications

General

Brand	NEC
Model	Xen Master
Category	Telephone
Language	English