1 - 302 Caller ID Display Assignment for CO/PBX Line
NEC Business Solutions Ltd Xen Master & Xen Axis
A6-324000-642-02 - Release 6.0
May 2003
3-44
System Mode
3
Submode
—
Data No.
44
PC Programming
a
+AI
Caller ID Display Assignment for
CO/PBX Line
General Description
Use this Memory Block to assign one Multiline Terminal, per CO/PBX, line to display Caller
ID Indication on incoming CO/PBX calls.
New Zealand - Analogue CO/PBX Line Scroll Feature is unavailable.
Display
Programming Procedures
1 Go off-line.
2 Press LK3 +
N+ DDto access the Memory Block.
3 Enter data using the dial pad.
Note: The following are used when entering data:
J to move the cursor left
L to move the cursor right
K~I to enter numeric data
Default Values
Not Specified
4 Press
Nto write the data.
5 Press
Pto go back on-line.
Related Programming
M.B. Number Memory Block Name
Refer to Chapter 2 Guide to Feature Programming
N
To display Caller ID Indication for normal incoming CO calls and CAR incoming calls, both Caller ID Indication and Ring
assignment must be assigned for the terminal in System Programming. A maximum of 15 Multiline Terminals can be
assigned system-wide to display caller identification for normal incoming CO calls and CAR incoming calls using Memory
Block 1-1-78 Caller ID Display Assignment for System Mode. A third Multiline Terminal can be assigned to display caller
identification for normal incoming CO calls, per CO line, using this Memory Block.
0 1 / 4 4 : C A L L I D 0 0
T I M E D I S P L A Y
CO/PBX
No.
(01~64)
Data
No.
Tel
Port No.
01~C0
Title
To Next Page
Loading...
Need help?
General
