NEC Xen Master - 1-1-28 Distinctive Ringing by Telephone or CO Selection

Distinctive Ringing by Telephone or CO Selection 1 - 57
Programming Manual May 2003
A6-324000-642-02 - Release 6.0 May 2003
1-1-28
System Mode
1
Submode
1
Data No.
28
PC Programming
a
+BTS
Distinctive Ringing by Telephone or
CO Selection
General Description
Use this Memory Block to assign distinctive ringing tone for each telephone or each CO/
PBX line.
Display
Settings
LK 1LK 2LK 3LK 4
The shaded area indicates the default setting.
TEL CO
LK 5 LK 6 LK 7 LK 8
Programming Procedures
1 Go off-line.
2 Press LK1 +
LK1 + BH to access the Memory Block.
3 Press the corresponding CO/PBX line key to change the data option.
4 Press
Nto write the data.
5 Press
Pto go back on-line.
Related Programming
M.B. Number Memory Block Name
3-07
CO/PBX Ringing Variation Selection
4-01
CO/PBX Ring Assignment (Day Mode)
4-02
CO/PBX Ring Assignment (Night Mode)
4-62
Telephone Ringing Variation Selection
N
1. TEL = Telephone Mode
Ringing tone is specified in Memory Block 4-62 Telephone Ringing Variation Selection.
2. CO = CO/PBX Line Mode
Ringing tone is specified for each CO/PBX line in Memory Block 3-07 CO/PBX Ringing Variation Selection.
2 8 : D S T R I N G T E L
T I M E D I S P L A Y
Data
No. Title
Setting
Data