1 - 168 Automated Attendant Direct Extension Ring or Ring Assignment
NEC Business Solutions Ltd Xen Master & Xen Axis
A6-324000-642-02 - Release 6.0
May 2003
1-4-22
System Mode
1
Submode
4
Data No.
22
PC Programming
a
+AU
Automated Attendant Direct
Extension Ring or Ring Assignment
General Description
Use this Memory Block to ring at an extension or normal ringing after the AA PBR
timer expires
Display
Programming Procedures
1 Go off-line.
2 Press LK1 + LK4 +
ACto access the Memory Block.
3 Use the dial pad to enter data.
Note: Use the following to enter data:
J to move the cursor LEFT
J to move the cursor RIGHT
K~I to enter numeric data
Press
Uto clear data at cursor.
Setting data:
KK~II
KKK
~III,
KKKK~IIII
(Depends what length the extension number has been assigned in HB1-2-03.)
Default Values
Not assigned.
4 Press
Nto write the data, and advance to the next A.A.No.
5 After the last entry, press
Nto write the data.
6 Press
Pto go back on-line.
Related Programming
M.B. Number Memory Block Name
Refer to Chapter 2 Guide to Feature Programming
N
1. If extension number is not assigned, then the system follows the assignment of MB 1-4-08 (release or becomes a
normal call).
2. The extension number can be physical, CAR or AA message.
3. This memory block is applicable to main software release 4.0 and above.
2 2 : A A T R F 1 =
T I M E D I S P L A Y
Data
No.
Title
Setting
Data
A.A. Msg.
No.
1~8
To Next Page
Loading...
Need help?
General
