NEC Xen Master - 8-2 System Speed Dial Memory Clear

System Speed Dial Memory Clear 1 - 417
Programming Manual May 2003
A6-324000-642-02 - Release 6.0 May 2003
8-2
System Mode
8
Spd-Clr-Sys
2
Data No.
—
PC Programming
a
+BE
System Speed Dial Memory Clear
General Description
Use this Memory Block to clear all System Speed Dial programming.
N
Before programming this procedure, please ensure you understand completely the
affect of erasing all System Speed Dial buffers in the system.
Display
Programming Procedures
1 Go off-line.
2 Press LK8 + LK2
to access the Memory Block.
3 When the system display prompt indicates CLR TEL SPD?, the first four CO/PBX lines light red.
4 Press
HAHIto enter the fixed password.
Note: When entering the password the top line of CO/PBX LEDs change from red to green each time a number of the password
is pressed.
5 Press
Nto write the data.
6 Press
Pto go back on-line.
Related Programming
No related programming is necessary for this Memory Block.
C L R S Y S S P D ?
T I M E D I S P L A Y
WWWW
Red Red Red Red
H =
WWWW
Green Red Red Red
WWWW
Green Green Red Red
A =
WWWW
Green Green Green Red
H =
WWWW
Green Green Green Green
I =