CO/PBX Ringing Variation Selection 1 - 269
Programming Manual May 2003
A6-324000-642-02 - Release 6.0
May 2003
3-07
System Mode
3
Submode
—
Data No.
07
PC Programming
a
+BCT
CO/PBX Ringing Variation Selection
General Description
Use this Memory Block to specify a ringing tone (Low, Medium, or High) for each CO/PBX
line.
Display
Settings
LK 1LK 2LK 3LK 4
The shaded area indicates the default setting.
Medium (M) Low (L) High (H)
LK 5 LK 6 LK 7 LK 8
Programming Procedures
1 Go off-line.
2 Press LK3 +
N + KGto access the Memory Block.
3 Press the corresponding CO/PBX line key to change the data option.
Note: Use the following when entering data:
R to go to the next CO/PBX Line No.
4 Press
Nto write the data.
5 Press
Pto go back on-line.
Related Programming
M.B. Number Memory Block Name
1-1-28
Distinctive Ringing by Telephone or CO Selection
N
1. This Memory Block is not applicable if Telephone is selected in Memory Block 1-1-28 Distinctive Ringing by
Telephone or CO Selection.
2. High, medium, or low ringing tone follows when transferring calls.
0 1 / 0 7 : D S T R I N G = M
T I M E D I S P L A Y
Setting
Data
CO/PBX
No.
(01~64)
Data
No.
Title
To Next Page
Loading...
