NEC Xen Master - 6-4 Telephone Mode Copy Assignment

Telephone Mode Copy Assignment 1 - 399
Programming Manual May 2003
A6-324000-642-02 - Release 6.0 May 2003
6-4
6
Submode
4
Data No.
—
Telephone Mode Copy Assignment
General Description
Use this Memory Block to enable copying data from one telephone port to another
telephone port or multiple consecutive telephone ports.
Example: To copy data of telephone port 10 to telephone ports 20~30:
1. Enter the original Tel. No. Using the dial pad, press
KK.
2. Press
N.
3. Enter the beginning of the Tel. Port No. (01~C0) range to be copied to. Using the dial
pad, press
BK.
Display
Programming Procedures
1 Go off-line.
2 Press LK6 +
LK4 to access the Memory Block.
3 Enter the Tel. Port No. to be copied.
Note: Use the following to enter data:
K~I to enter numeric data
U to clear all data when placed at cursor position
Related Programming
No related programming is necessary for this Memory Block.
T E L — —
Æ
T I M E D I S P L A Y
Title
Setting
Data
T E L — —
Æ
T I M E D I S P L A Y
Title
Setting
Data
— —
Æ
T E L —
T I M E D I S P L A Y
Setting
Data
Title
— —
Æ
T E L 2 0 —
T I M E D I S P L A Y
Setting
Data
Title