Caller Name Indication Selection 1 - 305
Programming Manual May 2003
A6-324000-642-02 - Release 6.0
May 2003
3-53
System Mode
3
Submode
—
Data No.
53
PC Programming
a
+AI
Caller Name Indication Selection
General Description
When a Caller ID number is detected, the Xen Axis/Master system can check the speed
dialling buffer for a match. If a name is assigned to a matched number, the name can be
displayed, depending on this assignment. This Memory Block must be set to TRK to enable
the incoming trunk name display to function.
Display
Settings
LK 1 LK 2 LK 3 LK 4
The shaded area indicates the default setting.
No Num Nam
LK 5 LK 6 LK 7 LK 8
TRK
Programming Procedures
1 Go off-line.
2 Press LK3 +
N + EC to access the Memory Block.
3 Press the corresponding CO/PBX line key to change the data option.
Note: Use the following to enter data:
J to move the cursor left
L to move the cursor right
K~I to enter numeric data
R to go to the next CO/PBX Line No.
4 Press
Nto write the data.
5 Press
Pto go back on-line.
Related Programming
M.B. Number Memory Block Name
Refer to Chapter 2 Guide to Feature Programming.
0 8 / 5 3 : I S I N D N U M
T I M E D I S P L A Y
CO/PBX
No.
(01~64)
Data
No.
Setting Data
(20 digits maximum)
To Next Page
Loading...
Need help?
General
