NEC Xen Master - 3-38 Automated Attendant Message to Trunk Selection

Automated Attendant Message to Trunk Selection 1 - 297
Programming Manual May 2003
A6-324000-642-02 - Release 6.0 May 2003
3-38
System Mode
3
Submode
—
Data No.
38
PC Programming
a
+AU
Automated Attendant Message to
Trunk Selection
General Description
Use this Memory Block to assign the Automated Attendant Message per-CO/PBX Trunk.
When the Automated Attendant Message is assigned to each CO/PBX Trunk, the system
automatically answers the incoming call and sends an Automated Attendant Message to
the calling party.
Display
Programming Procedures
1 Go off-line.
2 Press LK3 +
N+ CHto access the Memory Block.
3 Enter data using the dial pad.
Setting Data:
1~8 Automated Attendant Message 1~8
Note: Use the following to enter data:
R : Next CO/PBX Line No.
Default Values
Message 1
4 Press
Nto write the data.
5 Press
Pto go back on-line.
Related Programming
No related programming is necessary for this Memory Block.
N
The attendant telephone position must dial an Access Code to activate this feature.
0 1 / 3 8 : A A M S G = 1
T I M E D I S P L A Y
Data
No.
Setting
Data
CO/PBX
No.
(01~64)
Title