NEC Xen Master - 6-3 CO Line Mode Copy Assignment

CO Line Mode Copy Assignment 1 - 397
Programming Manual May 2003
A6-324000-642-02 - Release 6.0 May 2003
6-3
System Mode
6
Submode
3
Data No.
—
CO Line Mode Copy Assignment
General Description
Use this Memory Block to enable copying data from one CO/PBX line to another CO/PBX
line or multiple consecutive CO/PBX lines.
Example: To copy data of CO/PBX line 01 to CO/PBX line 05~07:
1. Enter the original CO/PBX No. Using the dial pad, press
KA.
2. Press
N.
3. Enter the beginning of the CO/PBX (02~64) range to be copied to. Using the dial pad,
press
KE.
Display
Programming Procedures
1 Go off-line.
2 Press LK6 +
LK3 to access the Memory Block.
3 Enter the CO/PBX line to be copied.
Note: Use the following to enter data:
K~I to enter numeric data
U to clear all data when placed at cursor position
Related Programming
No related programming is necessary for this Memory Block.
C O — —
Æ
T I M E D I S P L A Y
Title
Setting
Data
C O 0 1 — —
Æ
T I M E D I S P L A Y
Title
Setting
Data
— —
Æ
C O —
T I M E D I S P L A Y
Title
Setting
Data
— —
Æ
C O 0 5 —
T I M E D I S P L A Y
Title
Setting
Data