NEC Xen Master - 4-15 Intercom Master Hunt Number Forward Assignment

1 - 338 Intercom Master Hunt Number Forward Assignment
NEC Business Solutions Ltd Xen Master & Xen Axis
A6-324000-642-02 - Release 6.0 May 2003
4-15
System Mode
4
Submode
—
Data No.
15
PC Programming
a
+BTT
Intercom Master Hunt Number
Forward Assignment
General Description
Use this Memory Block to specify a telephone to ring when a Master Hunt Number specified
in Memory Block 4-14 Intercom Master Hunt Number Selection is busy.
Display
Programming Procedures
1 Go off-line.
2 Press LK4 +
AEto access the Memory Block.
3 Use dial pad to enter data. To set Tel. Port No. 01 to forward station number 300, enter
300.
Note: Use the following to enter data:
J to move the cursor left
L to move the cursor right
K ~ I to enter numeric data
U clear data when cursor is at setting data
Rto move to the next Tel Port No.
Setting Data: Forward Station Number is one of the following:
• 2 digit (00 ~ 99)
• 3 digit (000 ~ 999)
• 4 digit (0000 ~ 9999)
Default Values
All Telephones Not Specified
4 Press
Nto write the data.
5 Press
Pto go back on-line.
Related Programming
M.B. Number Memory Block Name
4-14
Intercom Master Hunt Number Selection
N
Telephone ports A0~C0 are ports 100~120.
0 1 / 1 5 : I C M F W D
T I M E D I S P L A Y
Data
No.
Tel Port
No.
(01~99)
A0~C0
Setting
Data
Title