NEC Xen Master - 3-28 Tie Line Reorder Tone Selection

Tie Line Reorder Tone Selection 1 - 287
Programming Manual May 2003
A6-324000-642-02 - Release 6.0 May 2003
3-28
System Mode
3
Submode
—
Data No.
28
PC Programming
a
+ALT
Tie Line Reorder Tone Selection
General Description
Use this Memory Block to specify whether or not to send a reorder tone to the originating
station when the number of a distant system is used to originate a call over a Tie line.
Display
Settings
LK 1 LK 2 LK 3 LK 4
The shaded area indicates the default setting.
Not Sending Sending
LK 5 LK 6 LK 7 LK 8
Programming Procedures
1 Go off-line.
2 Press LK3 +
N + BH to access the Memory Block.
3 Press the corresponding CO/PBX line key to change the data option.
Note: Use the following to enter data:
R to go to the next CO/PBX Line No.
4 Press
Nto write the data.
5 PressPto go back on-line.
Related Programming
M.B. Number Memory Block Name
3-14
Tie/DID Line Type Assignment
N
This Memory Block affects T1 channels assigned as Tie lines.
0 1 / 2 8 : R O T Y S
T I M E D I S P L A Y
Setting
Data
Title
Data
No.
CO/PBX
No.
(01~64)
Xen
System
Originating Side
Reorder
Tone
Sending
8 - 12
12
Distant
System

1111