1 - 154 Automated Attendant PBR Timeout Response Selection
NEC Business Solutions Ltd Xen Master & Xen Axis
A6-324000-642-02 - Release 6.0
May 2003
1-4-08
System Mode
1
Submode
4
Data No.
08
PC Programming
a
+AU
Automated Attendant PBR Timeout
Response Selection
General Description
Use this Memory Block to specify how a call answered by the Automated Attendant should
be processed if a dual-tone multifrequency (DTMF) tone is not received.
Display
Settings
LK 1 LK 2 LK 3 LK 4
The shaded area indicates the default setting.
Normal Call Release
LK 5 LK 6 LK 7 LK 8
Programming Procedures
1 Go off-line.
2 Press LK1 + LK4 +
KH to access the Memory Block.
3 Press the corresponding CO/PBX line key to change the data option.
4 Press
Nto write the data.
5 Press
Pto go back on-line.
Related Programming
M.B. Number Memory Block Name
Refer to Chapter 2 Guide to Feature Programming
N
1. When Normal Call is selected, and a DTMF tone is not received during the Automated Attendant message or during
the Automated Attendant Push Button Receiver (PBR) Release Timer time (20-second default), the system rings
selected stations using Memory Block 4-01 [CO/PBX Ring Assignment (Day Mode)] or Memory Block 4-02 CO/PBX
Ring Assignment (Night Mode).
2. When Release is selected, and a DTMF tone is not received during the Automated Attendant message or during the
Automated Attendant PBR Release Timer time (20-second default), the system drops the call after 30 seconds
regulated by a fixed timer.
0 8 : A A R E S N O R M A L
T I M E D I S P L A Y
Data
No. Title
Setting
Data
To Next Page
Loading...
Need help?
General
