NEC Xen Master - 1-1-52 PBX Line Ringing Pattern Selection

PBX Line Ringing Pattern Selection 1 - 81
Programming Manual May 2003
A6-324000-642-02 - Release 6.0 May 2003
1-1-52
System Mode
1
Submode
1
Data No.
52
PC Programming
a
+BCS
PBX Line Ringing Pattern Selection
General Description
Use this Memory Block to assign the initial ringing pattern for incoming calls on a PBX line.
Display
Settings
(Page 1)
LK 1
LK 2 LK 3 LK 4
Ring Pattern
A
Ring Pattern
B
Ring Pattern
C
Ring Pattern
D
LK 5 LK 6 LK 7 LK 8
Ring Pattern
E
Ring Pattern
F
Ring Pattern
G
Ring Pattern
H
(Page 2)
The shaded area indicates the default setting.
LK 9 LK 10 LK 11 LK 12
No Ring
LK 13 LK 14 LK 15 LK 16
Programming Procedures
1 Go off-line.
2 Press LK1 + LK1 +
EBto access the Memory Block.
3 Press corresponding CO/PBX line key to change data.
Note: Use the following to enter data:
Sto access the next page
Tto access the previous page
4 Press
Nto write data.
5 Press
Pto go back on-line.
Related Programming
No related programming is necessary for this Memory Block.
N
Do not program this Memory Block if Memory Block 1-1-59 Synchronous Ringing Selection is assigned Yes.
5 2 : P B X P T N B | 1
T I M E D I S P L A Y
Data
No.
Title
Setting
Data
Page
No.