Caller ID Preset Dial Outgoing CO Selection 1 - 365
Programming Manual May 2003
A6-324000-642-02 - Release 6.0
May 2003
4-44
System Mode
4
Submode
—
Data No.
44
PC Programming
a
+AI
Caller ID Preset Dial Outgoing
CO Selection
General Description
Use this Memory Block to assign the Trunk Group, Route Advanced Group, or Closed
Numbering Group that is seized for Caller ID Outgoing Calls. Use the Caller ID Scroll key to
access the Caller ID to be called.
New Zealand - Scroll Key Function does not work for Analogue CO Lines.
Display
Programming Procedures
1 Go off-line.
2 Press LK4 +
DD to access the Memory Block.
3 Use the dial pad to enter Setting Data.
Note: Use the following to enter data:
J to move the cursor left
L to move the cursor right
K~I to enter numeric data
R to select next Tel Port No.
Default Values
Not specified
4 Press
Nto write the data.
5 Press
Pto go back on-line.
Related Programming
No related programming is necessary for this Memory Block.
N
1. Setting Data is Access Code Assignment in Memory Blocks 1-1-46, 1-1-47, 1-1-48 Access Code (1-Digit, 2-Digit, or
3-Digit) Assignment. For example: Dial 9 (101) → Trunk Group 1.
2. Assign the Caller ID Scroll key using Memory Blocks 2-06 Line Key Selection for Tenant Mode or 4-12 Line Key
Selection for Telephone Mode.
3. Telephone ports A0~C0 are ports 100~120.
0 1 / 4 4 :
T I M E D I S P L A Y
Data
No.
Tel Port No.
(01~99)
A0~C0
Setting Data
To Next Page
Loading...
Need help?
General
