Automated Attendant Message Access Code (2-Digit) Assignment 1 - 161
Programming Manual May 2003
A6-324000-642-02 - Release 6.0
May 2003
1-4-15
System Mode
1
Submode
4
Data No.
15
PC Programming
a
+ AU
Automated Attendant Message
Access Code (2-Digit) Assignment
General Description
Use this Memory Block to enter a 2-digit code to route an incoming call from the Automated
Attendant.
Display
Programming Procedures
1 Go off-line.
2 Press LK1 + LK4 +
AE to access the Memory Block.
3 Use the dial pad to enter data.
Note: The following are used when entering data:
K~H to enter Automated Attendant message number
KK~IIto enter dial number
Default Values
4 Enter Setting Data. Press
Nto write the data and to advance the Dial Number.
5 After all data is entered, press
Nto write the data.
6 Press
Pto go back on-line.
Related Programming
M.B. Number Memory Block Name
Refer to Chapter 2 Guide to Feature Programming
1 5 : A A A C 1 = 0 0 = 0 3 0
T I M E D I S P L A Y
Data
No.
Title
Setting
Data
A.A. Msg.
No.
1~8
Dial
No.
Dial No. Funct. Code Contents
00 ~ 50 030 Specified Station Cal (0)
51 011
Bypass Automated
Attendant
52 015 Paging Zone A Call
53 016 Paging Zone B Call
54 017 Paging Zone C Call
55 ~ 87 000 Not Used
88 020 DSS 1 Call
89 021 DSS 2 Call
90~99 000 Not Used
To Next Page
Loading...
