PS Out of Area Tone Selection 1 - 133
Programming Manual May 2003
A6-324000-642-02 - Release 6.0
May 2003
1-2-28
System Mode
1
Submode
2
Data No.
28
PC Programming
a
+AP
PS Out of Area Tone Selection
General Description
Use this Memory Block to specify whether a call to a PS Handset which is currently out of
coverage area will receive Busy Tone (BT) or Ring Back Tone (RBT).
Display
Settings
LK 1LK 2LK 3LK 4
The shaded area indicates the default setting.
BT RBT
LK 5 LK 6 LK 7 LK 8
Programming Procedures
1 Go off-line.
2 Press LK1 + LK2 +
BH to access the Memory Block.
3 Press the corresponding CO/PBX line key to change the data option.
4 Press
Nto write data.
5 Press
Pto go back on-line.
Related Programming
No related programming is necessary for this Memory Block.
N
Ring Back Tone is the ringing tone head by the caller.
Refer to feature and specification M6, Multi-zone Digital Cordless for instructions with VM when PHS phone is set to
CFBNA and turn off or out of area.
2 8 : P S T O N E = B T
T I M E D I S P L A Y
Data
No.
Title
Setting
Data
To Next Page
Loading...
Need help?
General
