NEC Xen Master - 3-02 Trunk Status Selection

1 - 264 Trunk Status Selection
NEC Business Solutions Ltd Xen Master & Xen Axis
A6-324000-642-02 - Release 6.0 May 2003
3-02
System Mode
3
Submode
—
Data No.
02
PC Programming
a
+BCT
Trunk Status Selection
General Description
Use this Memory Block to specify whether a CO/PBX line is used for call origination and
termination or termination only.
Display
Settings
LK 1 LK 2 LK 3 LK 4
The shaded area indicates the default setting.
Out & In In
LK 5 LK 6 LK 7 LK 8
Programming Procedures
1 Go off-line.
2 Press LK3 +
N+ KBto access the Memory Block.
3 Press the corresponding CO/PBX line key to change the data option.
Note: Use the following to enter data:
R to go to the next CO/PBX Line No.
4 Press
Nto write the data.
5 Press
Pto go back on-line.
Related Programming
No related programming is necessary for this Memory Block.
0 1 / 0 2 O U T & I N
T I M E D I S P L A Y
CO/PBX
No.
(01~64)
Setting Data
Data
No.