Caller ID Display Assignment for System Mode 1 - 109
Programming Manual May 2003
A6-324000-642-02 - Release 6.0
May 2003
1-1-78
System Mode
1
Submode
1
Data No.
78
PC Programming
a
+AI
Caller ID Display Assignment for
System Mode
General Description
Use this Memory Block to assign up to 15 Multiline Terminals to display Caller ID Indication
for normal incoming CO/PBX calls or CO/PBX calls ringing a Call Arrival (CAR) key.
Display
Programming Procedures
1 Go off-line.
2 Press LK1 + LK1 +
GH to access the Memory Block.
3 Use the dial pad to enter Entry No.1 or 2 and Tel Port No.
Note: Use the following to enter data:
J to move the cursor left
L to move the cursor right
K~I to enter numeric data
Default Values
Not specified
4 Press
Nto write the data and advance to the next Entry No. After data for Entry No. 2 is entered, pressNagain. A total of
15 entries can be made.
5 Press
Pto go back on-line.
Related Programming
No related programming is necessary for this Memory Block.
N
1. To display Caller ID Indication for normal incoming and CAR incoming calls, Caller ID Indication and Ring Assignment
must be assigned for the terminal in system programming.
2. Fifteen Multiline Terminals can be assigned system-wide to display Caller ID.
3. A sixteenth terminal can be assigned to display Caller ID using another Memory Block.
7 8 : C A L L I D 1 = 0 0
T I M E D I S P L A Y
Data
No.
Title
1~7
Entry
No.
1~15
Tel Port No.
(00~99 A0~A9
B0~B9 CO)
To Next Page
Loading...
Need help?
General
