NEC Xen Master - 3-67 CO Line Ringing Pattern Selection for CO;PBX Line Mode

DIT Night Mode Delay Answer Enable 1 - 313
Programming Manual May 2003
A6-324000-642-02 - Release 6.0 May 2003
3-67
System Mode
3
Submode
—
Data No.
67
PC Programming
a
+BCT
CO Line Ringing Pattern Selection for
CO/PBX Line Mode
General Description
Use this Memory Block to specify the ring pattern for incoming calls or CO lines.
Display
Settings
(Page 1)
LK 1LK 2LK 3LK 4
The shaded area indicates the default setting.
—A B C
LK 5 LK 6 LK 7 LK 8
DEFG
(Page 2)
LK 1LK 2LK 3LK 4
H
LK 5 LK 6 LK 7 LK 8
Programming Procedures
1 Go off-line.
2 Press LK3 +
N + FG to access the Memory Block.
3 Press the corresponding CO/PBX line key to change the data option.
Note: The following to enter data:
S to go to the next page
T to go to the previous page
R to go to the next CO/PBX Line No.
Default Values
— = NON
4 Press
Nto write the data.
5 Press
Pto go back on-line.
Related Programming
M.B. Number Memory Block Name
4-53
CO Ringing Pattern Selection for Telephone Mode
4-56
CO Line Ringing Pattern by Telephone or CO Selection
0 1 / 6 7 : C O R N G – | 1
T I M E D I S P L A Y
CO/PBX
No.
(01~64)
Data
No.
Title
Setting
Data
Page
No.