1 - 296 Disconnect Recognition Time Selection
NEC Business Solutions Ltd Xen Master & Xen Axis
A6-324000-642-02 - Release 6.0
May 2003
3-33
System Mode
3
Submode
—
Data No.
33
PC Programming
a
+BCT
Disconnect Recognition Time
Selection
General Description
Use this Memory Block to specify the minimum time for a disconnected circuit to be
accessed again.
Display
Settings
(Page 1)
LK 1 LK 2 LK 3
LK 4
The shaded area indicates the default setting.
0 sec. .1 sec. .2 sec. .3 sec.
LK 5 LK 6 LK 7 LK 8
.4 sec. .5 sec. .6 sec. .7 sec.
(Page 2)
LK 1 LK 2 LK 3 LK 4
.8 sec. .9 sec. 1.0 sec. 1.1 sec.
LK 5 LK 6 LK 7 LK 8
1.2 sec. 1.3 sec. 1.4 sec. 1.5 sec.
Programming Procedures
1 Go off-line.
2 Press LK3 +
N + CC to access the Memory Block.
3 Press the corresponding CO/PBX line key to change the data option.
Note: Use the following to enter data:
S to go to the next page
T to go to the previous page
R to go to the next CO/PBX Line No.
4 Press
Nto write the data.
5 Press
Pto go back on-line.
Related Programming
No related programming is necessary for this Memory Block.
N
When a call origination on a CO/PBX line or Tie line is interrupted or dropped while in progress, and an attempt is made
to reseize the line, the seized line must be disconnected and cleared before it can be accessed again.
0 1 / 3 3 : D I S T 0 . 3 | 1
T I M E D I S P L A Y
Page
No.
Setting
Data
Title
Data
No.
CO/PBX
No.
(01~64)
To Next Page
Loading...
Need help?
General
