NEC Xen Master Programming Manual

Hookflash Time Selection 1 - 31
Programming Manual May 2003
A6-324000-642-02 - Release 6.0 May 2003
1-1-02
System Mode
1
Submode
1
Data No.
02
PC Programming
a
+BCM
Hookflash Time Selection
General Description
Use this Memory Block to specify the loop open time for a hookflash signal sent to the CO
or PBX when the Recall key on a Multiline Terminal is pressed. A Single Line Telephone
(SLT) generates a hookflash to the CO or PBX line when a Single Line Telephone hookflash
is assigned.
Display
Settings
(Page 1)
LK 1LK 2LK 3LK 4
The shaded area indicates the default setting.
20 ms. 40 ms. 60 ms. 80 ms.
LK 5 LK 6 LK 7 LK 8
100 ms. 140 ms. 160 ms. 200 ms.
(Page 2)
LK 1
LK 2 LK 3 LK 4
400 ms.
600 ms. 800 ms. 1 sec.
LK 5 LK 6 LK 7 LK 8
1.5 sec. 2 sec. 3 sec. 5 sec.
Programming Procedures
1 Go off-line.
2 Press LK1 + LK1
+KBto access the Memory Block.
3 Press the corresponding CO/PBX line key to change the data option.
Note: Use the following to enter data:
S to go to the next page
T to go to the previous page
4 Press
Nto write the data.
5 Press
Pto go back on-line.
Related Programming
M.B. Number Memory Block Name
1-1-46
Access Code (1-Digit) Assignment
1-1-47
Access Code (2-Digit) Assignment
1-3-02
SLT Hookflash Signal Selection
4-24
SLT Hookflash Assignment
0 2 : F L S H 1 0 0 m s 1
T I M E D I S P L A Y
D
a
t
a
No.
Title
Setting
Data
Page
No.

NEC Xen Master Specifications

General

Brand	NEC
Model	Xen Master
Category	Telephone
Language	English