NEC Xen Master - 1-2-19 Intercom Ring Pattern Selection

Intercom Ring Pattern Selection 1 - 123
Programming Manual May 2003
A6-324000-642-02 - Release 6.0 May 2003
1-2-19
System Mode
1
Submode
2
Data No.
19
PC Programming
a
+BI
Intercom Ring Pattern Selection
General Description
Use this Memory Block to select a ring pattern when intercom calls are made.
Display
Settings
(Page 1)
LK 1 LK 2 LK 3
LK 4
The shaded area indicates the default setting.
Tone Off Tone On Pattern A Pattern B
LK 5 LK 6 LK 7 LK 8
Pattern C Pattern D Pattern E Pattern F
(Page 2)
LK 1LK 2LK 3LK 4
Pattern G Pattern H
LK 5 LK 6 LK 7 LK 8
Programming Procedures
1 Go off-line.
2 Press LK1 + L2 +
AI to access the Memory Block.
3 Press the corresponding CO/PBX line key to change the data option.
Note: Use the following to enter data:
S to go to the next page
T to go to the previous page
4 PressNto write the data.
5 Press
Pto go back on-line.
Related Programming
No related programming is necessary for this Memory Block.
1 9 : I C M P T N B | 1
T I M E D I S P L A Y
Data
No.
Title
Setting
Data
Page