Second Delay Announcement Repeat Interval Time Selection 1 - 107
Programming Manual May 2003
A6-324000-642-02 - Release 6.0
May 2003
1-1-75
System Mode
1
Submode
1
Data No.
75
PC Programming
a
+AR
Second Delay Announcement Repeat
Interval Time Selection
General Description
Use this Memory Block to specify the interval time to repeat Second Delay Announcement
to the calling party.
Display
Settings
LK 1 LK 2 LK 3 LK 4
The shaded area indicates the default setting.
0 sec. 10 sec. 20 sec. 30 sec.
LK 5 LK 6 LK 7 LK 8
40 sec. 50 sec. 60 sec. No Limit
Programming Procedures
1 Go off-line.
2 Press LK1 + LK1 +
GE to access the Memory Block.
3 Press the corresponding CO/PBX line key to change the data option.
4 Press
Nto write the data.
5 Press
Pto go back on-line.
Related Programming
M.B. Number Memory Block Name
1-1-73
First to Second Delay Announcement Interval Time Selection
1-1-74
Second Delay Announcement Repeat Selection
3-41
ACD/UCD Delay Announcement Assignment
N
This Memory Block does not display unless the MIFA-U13 ETU is installed.
7 5 : M S G 2 R P E T = 2 0 s
T I M E D I S P L A Y
Data
No.
Setting
Data
Title
To Next Page
Loading...
