NEC Xen Master Programming Manual

CO/PBX Outgoing Digit Add Assignment 1 - 77
Programming Manual May 2003
A6-324000-642-02 - Release 6.0 May 2003
1-1-50
System Mode
1
Submode
1
Data No.
50
PC Programming
a
+BCS
CO/PBX Outgoing Digit Add
Assignment
General Description
Use this Memory Block to specify up to 10 additional digits when a trunk in the Trunk Group
or Route Advance block assigned in Memory Block 1-1-49 Networking Trunk Group/Route
Advance Assignment is seized, and a number is dialled.
Display
Programming Procedures
1 Go off-line.
2 Press LK1 +
LK1 + EK to access the Memory Block.
3 Use dial pad to enter digits to be added.
Note: Use the following to enter data:
J to move the cursor left
L to move the cursor right
K~Ito enter numeric data
U to clear all data
Q+ J to enter *
Q+ L to enter #
Default Values
Not Specified
4 Press
Nto write selected data.
5 Press
Pto go back on-line.
Related Programming
M.B. Number Memory Block Name
1-1-49
Networking Trunk Group/Route Advance Assignment
5 0 : 0 1 =
T I M E D I S P L A Y
Data
No.
Closed
Number Block
01~16
Add Digit
10 Max. (0~9, *, #)

NEC Xen Master Specifications

General

Brand	NEC
Model	Xen Master
Category	Telephone
Language	English