1 - 164 Automated Attendant Delay Announcement Assignment
NEC Business Solutions Ltd Xen Master & Xen Axis
A6-324000-642-02 - Release 6.0
May 2003
1-4-18
System Mode
1
Submode
4
Data No.
18
PC Programming
a
+AU
Automated Attendant Delay
Announcement Assignment
General Description
Use this Memory Block to specify the order for the Automated Attendant messages that are
played when in the Delayed Announcement Mode.
Display
Settings
LK 1 LK 2 LK 3 LK 4
The shaded area indicates the default setting.
Not Specified
(NONE)
MSG1 MSG2 MSG3
LK 5 LK 6 LK 7 LK 8
MSG4 MSG5 MSG6 MSG7
LK9 LK10 LK11 LK12
MSG8
Programming Procedures
1 Go off-line.
2 Press LK1 + LK4 +
AHto access the Memory Block.
3 Use the dial pad to enter the 1
st
message number.
Use the Line Key to enter the Setting Data.
Note: Use the following to enter data:
J to move the cursor left
L to move the cursor right
K ~ I to enter numeric data
Default Values
1
st
Message No. 1~8 : Not Specified
4 Pressing
N will write the selected data and advance to Memory Block 1-4-19 Automated Attendant 1
st
to 2
nd
Delay Announcement Interval Time Selection
5 Press
Pto go back on-line.
Related Programming
M.B. Number Memory Block Name
1-4-19
Automated Attendant 1
st
to 2
nd
Delay Announcement Interval Time Selection
1-4-20
Automated Attendant Delay Announcement Disconnect Time Selection
N
1. This Memory Block must be set to YES for Automated Attendant to be enabled.
2. This Feature is not related to Memory Block 3-41 ACD/UCD Delay Announcement Assignment.
1 8 : ( 1 ) 2 N D = N O N E
T I M E D I S P L A Y
Data
No.
Title
1st
Message
No.
Setting Data
2nd
Message No.
To Next Page
Loading...
Need help?
General
