May 2003
Programming Manual 1 - 7
A6-324000-642-02 - Release 6.0
May 2003
2.5.3 Entering Programming Mode
To program information in the system, the following digital Multiline Terminals
can be used as programming stations. Two stations, ports 01 and 02, are
automatically assigned as programming stations.
 DTU-16D-1A (BK)/(WH) TEL
 DTU-32D-1A (BK)/(WH) TEL
 ETW-16C-1A (BK)/(SW) TEL
 ETW-16D-1A (BK)/(SW) TEL
 ETW-24S-1A (BK)/(SW) TEL
New Zealand - ETW-type Telephones are unavailable.
To enter programming mode, the station must be off-line. To go off-line:
1. Press
T.
2. Press
U.
3. DialL, K, andJin sequence. The Multiline Terminal LCD
indicates program mode is now active.
While off-line, the programming terminal cannot be signaled by any system
station. Off-line mode does not timeout.
2.5.4 Page Switching
In Memory Block 1-1-18 (System Speed Dial Restriction by Tenant) tenant
numbers 00~07 are assigned to Flexible Line keys on the first page. Tenant
number 08~15 are assigned to the Flexible Line keys on the second page.
The tenant number corresponding to Flexible Line key 1 of the current page
is displayed on the right side of the display.
During system programming, a value (data) is assigned to each Flexible Line
key. When there are more values than Flexible Line keys, value
assignments are displayed on additional pages. The associated data can be
entered on that page. The page number is displayed at the right side of the
LCD.
Figure 1-3 Page Switching for 16-Key and 24-Key multiline Terminals shows
an example of CO/PBX line keys on each page and their corresponding
tenant numbers. In all cases each page is represented by eight line keys.
P R O G R A M M O D E
T I M E D I S P L A Y
To Next Page
Loading...
Need help?
General
