Programming Manual May 2003
Tie Line/CO/PBX Incoming Signal Detect Time Selection 1 - 279
A6-324000-642-02 - Release 6.0
May 2003
Programming Procedures
1 Go off-line.
2 Press LK3 +
N + AI to access the Memory Block.
3 Press the corresponding CO/PBX line key to change the data option.
Note: Use the following to enter data:
S to go to the next page
T to go to the previous page
R to go to the next CO/PBX Line No.
4 Press
Nto write the data.
5 Press
Pto go back on-line.
Related Programming
M.B. Number Memory Block Name
3-14
Tie/DID Line Type Assignment
N
1. For the second dial tone method and the immediate method, the time is fixed at 30 ms.
Sending Acknowledgment Signal
Receiving Side
Incoming Signal Detection
Time
DC Loop Supervision
To Next Page
Loading...
