NEC Business Solutions Ltd Xen Master & Xen Axis
1 - 392 Tie Line Networking Tandem Connection Assignment
A6-324000-642-02 - Release 6.0
May 2003
Programming Procedures
1 Go off-line.
2 Press LK5 +
N+ KA to access the Memory Block.
3 Press the corresponding CO/PBX line key to change the data option. Operation data includes:
Note: Use the following to enter data:
J to move the cursor left
L to move the cursor right
S to go to the next page
T to go to the previous page
R to go to the next Trunk Group No.
4 Press
Nto write the data.
5 Press
Pto go back on-line.
Related Programming
M.B. Number Memory Block Name
3-03
Trunk-to-Trunk Group Assignment
4-09
Telephone to Tenant Assignment
N
Tandem connection of Trunk Group-to-Trunk Group must be specified separately.
CO/PBX
Line LED
Off On
Data No Yes
There is no default setting.
To Next Page
Loading...
Need help?
General
