Schweitzer Engineering Laboratories SEL-751 - Table 7.61 FTP and MMS Wildcard Usage Examples; Table 7.62 Ymodem Wildcard Usage Examples

7.63
Date Code 20170927 Instruction Manual SEL-751 Relay
Communications
Communications Protocols
Batch File Access
Files can be accessed as a batch by using the supported wild card character, *.
FTP and MMS Wild Card Usage
Table 7.61 shows examples using supported wild cards. Note that these wild
cards may be appended to a directory path (e.g., /specified_directory/*.txt).
Ymodem Wild Card Usage
Event, report, and diagnostic files can also be accessed as a batch using wild
cards.
CLDP.TXT See Reports Directory (Read-Only) on page 7.60 1, 2, C N/A
LDP.TXT See Reports Directory (Read-Only) on page 7.60 1, 2, C N/A
CSER.TXT See Reports Directory (Read-Only) on page 7.60 1, 2, C N/A
SER.TXT See Reports Directory (Read-Only) on page 7.60 1, 2, C N/A
SET_HMI.zds See HMI Directory (Read and Write) on page 7.62 1, 2, C 2, C
CDP.zds See HMI Directory (Read and Write) on page 7.62 1, 2, C 2, C
HMI_ALL.zip See HMI Directory (Read and Write) on page 7.62 1, 2, C N/A
a
Calibration settings are included only when accessed at Access Level C.
Table 7.60 Files Available for Ymodem Protocol (Sheet 2 of 2)
File Name Description
Read
Access
Level
Write
Access
Level
Table 7.61 FTP and MMS Wildcard Usage Examples
Usage Description Example Note
*xyz Lists all files and/or subdirectories
in a specified directory whose
name (including extension) ends
with xyz.
/*.TXT List all files with the
.TXT extension.
abc* Lists all files and/or subdirectories
in a specified directory whose
name begins with abc.
/SETTINGS/SET* List all settings files
that start with SET.
*mno* Lists all files and/or subdirectories
in a specified directory whose
name contains mno.
/EVENTS/*_100* List all events that
contain _100 in the
ID number.
Table 7.62 Ymodem Wildcard Usage Examples
Usage Description Example Note
*xyz Lists all files that end
with xyz.
FILE DIR
HIS*.TXT
Lists all of the metering files (HIS-
TORY.TXT, HIF_HISTORY.TXT)
abc* Lists all files whose
name begins with abc.
FILE READ
HR_10007*
Retrieves all of the three files for
the COMTRADE event 10007
(HR_10007.CFG, HR_10007.DAT,
and HR_10007.HDR)
NOTE: Ymodem protocol does not
support wild cards for settings files.