Alcatel-Lucent OmniAccess 5740 - Page 1031

QoS Configuration
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
1005
Alcatel-Lucent
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Configuration Guide
AUTO QOS DIFF-SERV CONFIGURATION
Auto QoS Diff-serv create policies and classes as required by standard Diff-serv
application.
Note: Auto Diff-serv is applied only in the egress direction of an interface as RED and
marking of outgoing packets are involved.
T
O CONFIGURE AUTO QOS DIFF-SERV
EXAMPLE
ALU(config-if Serial0/1:3)# auto qos diff-serv
ALU(config-if Serial0/1:3)# no auto qos diff-serv
A
UTO QOS TEMPLATE
Auto-QoS template command creates a set of match-lists, traffic classes and a
policy map automatically. You can edit or modify these match lists and class -
maps.
The policy is not applied on to the interface automatically - you have to explicitly
apply this template on an interface.
T
O CONFIGURE AUTO QOS TEMPLATE
EXAMPLE
ALU(config)# auto qos template voip p1
ALU(config)# no auto qos template voip p1
Auto-QoS template removed
Command (in ICM) Description
auto qos diff-serv This command enables Auto QoS Diff-
Serv on an interface (assured forwarding
and expedited forwarding).
no auto qos diff-serv This command disables Auto QoS Diff-
Serv on an interface.
Command (in CM) Description
auto qos template {diff-serv|
voip} <policy-map name>
This command creates an Auto QoS
VoIP/Diff-serv template policy.
This policy is to be attached to an
interface using the ‘service policy
command’. See “To Attach a Policy Map
to an Interface”.
no auto qos template {diff-
serv|voip} <policy-map name>
This command removes the specified
Auto QoS template.