TF Configuration on OmniAccess 5740 USG
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
967
Alcatel-Lucent
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Configuration Guide
TF CONFIGURATION ON OMNIACCESS 5740 USG
Consider a scenario, a corporate XYZ with LAN (GigE 3/1) is connected to the
internal network of XYZ and the WAN (GigE 3/0) is facing the external gateway.
Other than IP and ARP traffic, XYZ intends the non-IP traffic to be bridged across
the TF'ed ports.
In order to achieve this, you need to configure TF on an interface, and attach the
TF policy with pass through protocol as ‘nonip’ on the interface.
CONFIGURATION STEPS
Quick Steps
1. Create a TF policy, and configure the pass through protocol
2. Configure TF on an interface.
Detailed Steps
Step 1: Create a TF policy for bridging non-IP packets transparently
ALU(config)# transparent-forward TF1
ALU(config-transparent-forward-TF1)# pass-through
protocol nonip
Step 2: Configure an interface, apply the TF policy for forwarding IP, ARP and
non-IP packets coming in on GigE 3/1 to GigE 3/0
ALU(config)# interface GigabitEthernet3/1
ALU(config-if GigabitEthernet3/1)# transparent-forward
TF1 interface GigabitEthernet 3/0
SHOW COMMANDS
Verify the TF policy configuration by using the following show command:
ALU(config)# show transparent-forward
!
transparent-forward TF1
pass-through protocol nonip
exit
!
interface GigabitEthernet3/1
transparent-forward TF1 interface GigabitEthernet3/0
exit
!
To Next Page
Loading...
Need help?
General
