Filter and Firewall
Left running head:
Chapter name (automatic)
794
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Configuration Guide
Alcatel-Lucent
CUSTOMIZED-SERVICE RULE BASED ALG CONFIGURATION
The OmniAccess 5740 USG now supports the customized-service rule based
ALG (Application Level Gateway) configuration. By definition, the ALGs operate
on well known ports or standard ports. The customized service gives an additional
point of invocation of the ALG and the capability to remove or disable the
invocation from well-known ports.
You also have the flexibility to use ALG based on the rules defining specific
service configuration apart from those on well-known ports.
If you do not want to use ALG for a particular service, configure “service-none”.
This customization of invoking ALG on user configured ports is an enhancement
specific to OmniAccess and is not available on other vendor systems.
Note: ALG configuration is system wide firewall configuration and is not specific to any
interface.
CUSTOMIZING ALG COMMANDS
TO CONFIGURE CUSTOMIZED SERVICE
EXAMPLE
ALU(config)# customized-service
Command (in CM) Description
customized-service This command is used to configure ALG
rule.
This also enters into customized service
configuration mode.
To Next Page
Loading...
Need help?
General
