Alcatel-Lucent OmniAccess 5740 - PPP Optional Parameters

PPP Configuration
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
337
Alcatel-Lucent
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Configuration Guide
PPP OPTIONAL PARAMETERS
LINK CONTROL PROTOCOL CONFIGURATION
The LCP (Link Control Protocol) provides a method of establishing, configuring,
maintaining, and terminating the PPP connection. In order to be sufficiently
versatile and portable to a wide variety of environments, PPP provides the LCP.
LCP is used to automatically negotiate the authentication protocol, MRU, or to
detect a looped-back link, etc.
T
O INITIATE LCP NEGOTIATION MANUALLY
EXAMPLE
ALU(config-if Serial1/0:0)# ppp lcp negotiate
Note: LCP negotiation is automatically started when the encapsulation is set to PPP or when
the link is administratively brought up on a PPP interface, or when the MTU is
changed on the interface.
T
O SET ECHO-INTERVAL
E
XAMPLE
ALU(config-if Serial1/0:0)# ppp lcp echo-interval 200
ALU(config-if Serial1/0:0)# no ppp lcp echo-interval
Command (in ICM) Description
ppp lcp negotiate This command is used to initiate the LCP
negotiation on the interface.
Command (in ICM) Description
ppp lcp echo-interval <0-255> This command is used to set the interval
between the LCP echo requests sent.
“0” implies that no echo requests are
sent.
no ppp lcp echo-interval The “no” command sets the echo-
interval to its default value. The default
value is 10 seconds.