CC Configuration
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
475
Alcatel-Lucent
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Configuration Guide
CC CONFIGURATION
This section covers the following:
• “CC Configuration Steps”
• “Elements Used in Configuring CC”
• “Rules within Match-lists”
• “Lists in CC”
• “Nesting Of Match-lists”
• “Show commands in CC”
• “Deletion Commands in CC”
CC CONFIGURATION STEPS
The following section gives the overview of the steps required to configure the
common classifiers on the OmniAccess 5740 USG, which includes the “Lists and
Match-lists”.
Step 1: At the inception, you are required to have a thorough knowledge of the
elements used in configuring CC before proceeding further. The elements give a
deeper understanding of the concept and framework required to configure lists,
match-lists and arguments used for configuring advanced rulesets within the
match-lists. See “Elements Used in Configuring CC”
Step 2: Configure Match-lists. See “To Configure a Match-list”
Step 3: Configure the appropriate rules within the match-list sub-configuration
mode. These rules are a combination of different elements and their arguments.
See “Rules within Match-lists”
Step 4: You are required to have a thorough knowledge of Lists (though “lists” are
optional), since it acts as a powerful tool to minimize the number of rules within a
match-list. See “To Configure a List”
Step 5: A match-list can be referenced and included in a new match-list. See
“Nesting Of Match-lists”
Step 6: To view the configuration, see “Show commands in CC”.
Step 7: The configured rules and match-lists can be removed with the help of the
respective deletion commands. See “Deletion Commands in CC”
To Next Page
Loading...
Need help?
General
