DHCP (Dynamic Host Configuration Protocol) Client
Left running head:
Chapter name (automatic)
1058
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Configuration Guide
Alcatel-Lucent
DHCP CLIENT CONFIGURATION
This chapter includes the following sections:
• “DHCP Client Configuration Steps”
• “DHCP Client Configuration Flow”
• “DHCP Client Configuration Commands”
• “DHCP Client Test Scenarios using OmniAccess 5740 USG”
DHCP CLIENT CONFIGURATION STEPS
The following steps details the procedure to configure DHCP client on
OmniAccess 5740 USG:
Step 1: Create a DHCP client object. See “To Create a DHCP Client Object”
Step 2: Configure host name of the DHCP client. See “To Configure Host Name
of the DHCP Client” (Optional)
Step 3: Configure DHCP client object optional parameters. See “To
Configure DHCP Client Object Parameters”
• Configure vendor class identifier for a client object. See “To Configure
Vendor Class Identifier”
• Configure client identifier for a client object. See “To Configure Client
Identifier”
• Specify the IP address to be obtained from the server. See “To Request a
Specific IP Address From the DHCP Server”
• Configure user class of the client interface. See “To Configure User Class
of the Client Interface”
• Specify the request type to be sent to the DHCP server. See “To Specify
the Request Type”
• Specify the DHCP option to be obtained from the server. See “To Request
for a Specific DHCP Option from the Server”
Note: Configure the required DHCP options from the server with in a client object before
attaching the client object to an interface.
To Next Page
Loading...
