Filter and Firewall
Left running head:
Chapter name (automatic)
732
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Configuration Guide
Alcatel-Lucent
L2 (LAYER2) FILTER CONFIGURATION COMMANDS
MAC filters can be configured on OmniAccess 5740 USG like IP filters though the
included match-list will be based on Ethernet parameters only (source MAC,
destination MAC, 802.1Q class of service and VLAN tag value).
For more information on configuring MAC based match-list, refer to “Common
Classifiers” chapter.
T
O CONFIGURE MAC FILTER/L2 FILTER
EXAMPLE
ALU(config)# l2 filter F1
ALU(config-filter-F1)#
ALU(config)# no l2 filter F1
Command (in CM) Description
l2 filter <name> This command configures a L2 filter.
no l2 filter <name> [force] This command is used to delete a L2
filter.
You cannot delete a filter if it is attached
to any interface. First detach the filter
from the interface to delete the filter.
To force deletion of a filter, use the “force”
command. When "force" is used, the filter
gets removed from the interface it is
attached to.
To Next Page
Loading...
