Alcatel-Lucent OmniAccess 5740 - DHCP Relay Configuration Commands

DHCP Relay Configuration
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
1081
Alcatel-Lucent
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Configuration Guide
DHCP RELAY CONFIGURATION COMMANDS
TO RELAY DHCP PACKETS TO SERVER
EXAMPLE
ALU(config-if GigabitEthernet3/0)# ip dhcp relay 192.168.1.1
ALU(config-if GigabitEthernet3/0)# no ip dhcp relay 192.168.1.1
T
O RELAY REQUESTS TO INTERFACE
EXAMPLE
ALU(config-if GigabitEthernet3/0)# ip dhcp relay interface
GigabitEthernet 3/1
ALU(config-if GigabitEthernet3/0)# no ip dhcp relay interface
GigabitEthernet 3/1
Command (in ICM) Description
ip dhcp relay <dhcp server ip-
address>
This command is entered in the Interface
Configuration mode.
This command is used to specify the
DHCP server to which the DHCP
requests are to be forwarded.
Note: A maximum of four DHCP
relay destinations can be
configured per interface.
no ip dhcp relay [<dhcp server
ip-address>]
This command is used to disable all/a
specific relay configured on an interface.
Command (in ICM) Description
ip dhcp relay interface
<interface-name>
This command is entered in the Interface
Configuration Mode.
This command is used to configure the
interface through which the DHCP relay
requests have to be rebroadcasted.
no ip dhcp relay interface
<interface-name>
This command is used to disable relay of
DHCP requests to the specified
interface.