Destination NAT Configuration
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
709
Alcatel-Lucent
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Configuration Guide
NAT DEBUG COMMANDS
This section lists the debug commands in NAT.
T
O ENABLE/DISABLE DEBUGGING ON NAT
Notes: 1. saddr == source address
2. daddr == destination address
3. sport == source port
4. dport == destination port
EXAMPLE
ALU# debug firewall nat
Command (in SUM/CM) Description
debug firewall
{session|filter|nat|attack|alg
|intrusion|selector [saddr
<ip-address>|daddr <ip-
address>|protocol <number> |
sport <number>|dport
<number>][output|permanent]|
all [detail-level]}
This command turns on the debugging
functionality for NAT on OmniAccess
5740 USG.
no debug firewall
{session|filter|nat|attack|alg
|intrusion|selector [saddr
<ip-address>|daddr <ip-
address>|protocol <number> |
sport <number>|dport
<number>][output|permanent]|
all [detail-level]}
Use this command to turn off the
debugging functionality for NAT.
To Next Page
Loading...
