Alcatel-Lucent OmniAccess 5740 - MLPPP Configuration Example

MLPPP Configuration Example
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
379
Alcatel-Lucent
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Configuration Guide
MLPPP CONFIGURATION EXAMPLE
The following example illustrates the configuration of a bundle interface and then
the member link configuration.
To configure MLPPP, first a bundle interface needs to be configured, and then
MLPPP encapsulation is set on interfaces to link them to a bundle.
a) Configuration of bundle interface
ALU> enable
ALU#configure terminal
ALU(config)#interface mlppp 10
ALU(config-if mlppp10)#ip address 3.3.3.3 255.255.255.0
ALU(config-if mlppp10)#no shutdown
ALU(config-if mlppp10)#exit
ALU(config)#
b) Configuration of Serial interfaces and linking them to the bundle
ALU(config)#controller T1 0/0
ALU(config-controller T1)#channel-group 0 timeslots 1
ALU(config-controller T1)#exit
ALU(config)#
ALU(config)#interface Serial 0/0:0
ALU(config-if Serial0/0:0)#no shutdown
ALU(config-if Serial0/0:0)#encapsulation mlppp 10
ALU(config)#controller T1 0/0
ALU(config-controller T1)#channel-group 1 timeslots 2
ALU(config-controller T1)#exit
ALU(config)#
ALU(config)#interface Serial 0/0:1
ALU(config-if Serial0/0:1)#no shutdown
ALU(config-if Serial0/0:1)#encapsulation mlppp 10
c) Viewing MLPPP Configuration
ALU(config)#show interfaces Serial 0/0:0
Serial0/0:0 is up, line protocol is up
Internet address not set
MTU 1500 bytes, BW 64 Kbit, DLY 0 usec,
reliability 255/255, txload 247/255, rxload 0/255
Loopback not set
Encapsulation mlppp, MLPPP Bundle Id: 10
keepalive set (10 sec)
LCP: Open
Last input never, output never, output hang never
Last clearing of "show interface" counters never
Queueing strategy: fifo