Alcatel-Lucent OmniAccess 5740 - Page 406

Multilink Point to Point Protocol
Left running head:
Chapter name (automatic)
380
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Configuration Guide
Alcatel-Lucent
Output queue: 0/0 (size/max) 0 drops; Input queue: 0/0 (size/max) 0
drops
Conversations: 0/0/0/0 (active/max active/max total)
Reserved Conversations: 0/0 (allocated/max allocated)
Available Bandwidth 64 kilobits/sec
5 minute input rate 56 bits/sec, 0 packets/sec
5 minute output rate 62144 bits/sec, 55 packets/sec
118 packets input, 2415 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
9688 packets output, 2698346 bytes, 0 underruns
0 output errors, 0 collisions, 0 interface resets
0 output buffer failures, 0 output buffers swapped out
0 carrier transitions
Timeslot(s) Used:1 (64Kbps each), Transmitter delay is 0 flags
ALU(config)#show interfaces mlppp 10
mlppp10 is up, line protocol is up
Internet address is 3.3.3.3/24
MTU 1494 bytes, BW 128 Kbit, DLY 0 usec,
reliability 255/255, txload 237/255, rxload 0/255
Encapsulation mlppp, loopback not set
IPCP: Initial
Last input never, output never, output hang never
Last clearing of "show interface" counters never
2 packets input (0 Control packets, 0 Data packets), 28 bytes
2 packets output (0 Control packets, 0 Data packets), 28 bytes
0 packets dropped, 0 giants received
Fragmentation: Fragment Delay 0 ms
0 fragmented, 0 couldn't fragment
0 fragments created, 0x0 sent sequence
Reassembly: Slippage MRU 32
0 fragments in reassembly list
0 lost fragments, 0 reordered
0 discarded fragments, 0 reassembled
0 lost received, 0 couldn't reassemble
0 fragments received, 0x0 received sequence
ALU(config)# show mlppp 10
MLPPP bundle 10 link state information:
IPCP: Open
MEMBER LINKS LCP AUTH CLIENT AUTH SERVER
Serial0/0:1 Open -----
Serial0/0:0 Open -----