Alcatel-Lucent OmniAccess 5740 - VRF Show Commands; Example

VRF-CE Configuration
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
673
Alcatel-Lucent
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Configuration Guide
VRF SHOW COMMANDS
EXAMPLE
ALU(config)# show ip vrf interfaces ALU
Interface IP Address VRF Protocol
GigabitEthernet3/1 1.1.1.1 ALU Down
ALU(config)# show ip vrf interfaces ALU-vrf
Interface IP Address VRF Protocol
GigabitEthernet3/0 2.2.2.2 ALU-vrf up
ALU(config)# show ip protocols vrf ALU-vrf
Routing Protocol is "ospf 1"
Invalid after 3600 seconds, hold down 5, flushed after 3600 seconds
Router Id 4.4.4.4
Number of Areas in this router 1. 1 normal 0stub 0 nssa
Outgoing update filter list for all interfaces is not set
Incoming update filter list for all interfaces is not set
Routing for Networks:
4.0.0.0/8
Routing Information Sources:
Gateway Distance Last Update
4.4.4.1 110 00:05:56
Distance: (default is 110)
Routing Protocol is "bgp 100"
IGP synchronization is enabled
Automatic route summarization is disabled
Command (in CM) Description
show ip vrf [interfaces
<vrf-name>]
Displays information on the defined VRF
instances.
• The “interfaces” keyword gives the
information of the VRFs configured on all
the interfaces.
• If the VRF name is specified, then it
displays all the interfaces associated with
the specified VRF.
show ip protocols [vrf
<vrf-name>]
Displays routing protocol information
associated with a VRF.
show ip route [vrf <vrf-
name>] [{network-number|ip-
address/prefix length}
[longer-prefixes]|ospf [<1-
65535>]|connected|bgp|rip|
summary|supernets-only]
Displays the IP routing table for the default
VRF.
If the VRF name is specified, then it displays
the IP routing table for the specified VRF.