Alcatel-Lucent OmniAccess 5740 - E1 Configuration Commands

E1 Configuration
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
259
Alcatel-Lucent
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Configuration Guide
E1 CONFIGURATION COMMANDS
This section provides details about the commands that are used in configuring an
E1 interface.
T
O SET THE CARD TYPE TO E1
E
XAMPLE
The following example sets the card type of the E1 controller:
ALU(config)# card type E1 0
Note: The line card is not functional until card type is set. Reboot/Reload the chassis to
change the card type, which will remove the previous configuration.
T
O CONFIGURE AN E1 CONTROLLER
E
XAMPLE
ALU(config)# controller E1 0/0
ALU(config-controller E1)#
Command (in CM) Description
card type {E1|T1} <slot> Use this command to set the card
type. Use E1 keyword to set the card
type to E1.
Command (in CM) Description
controller {E1|T1} <slot/port> This command configures an E1 or T1
controller.
Use E1 keyword to configure an E1
controller.